configNEW.txt

overscan_left=17
overscan_right=0
overscan_top=0
overscan_bottom=0

framebuffer_width=704
framebuffer_height=576
dpi_mode=87

#234p@50
#hdmi_timings=356 1 16 32 40 288 1 3 2 19 0 0 0 50 0 7363200 1 #PAL OLD
hdmi_timings=352 1 16 32 40 288 1 3 2 19 0 0 0 50 0 7363200 1 #PAL NEW
#hdmi_timings=384 1 16 32 40 288 1 3 2 19 0 0 0 50 0 7363200 1 #NTSC

# Enable audio (loads snd_bcm2835)
dtparam=audio=on

# Additional overlays and parameters are documented
# /boot/firmware/overlays/README

# Automatically load overlays for detected cameras
camera_auto_detect=1

# Automatically load overlays for detected DSI displays
#display_auto_detect=1

# Automatically load initramfs files, if found
#auto_initramfs=1

# Enable DRM VC4 V3D driver
#dtoverlay=vc4-kms-v3d
#max_framebuffers=2

# Don't have the firmware create an initial video= setting in cmdline.txt.
# Use the kernel's default instead.
disable_fw_kms_setup=1

# Run in 64-bit mode
arm_64bit=1

# Disable compensation for displays with overscan
disable_overscan=0
#disable_overscan=1
# Run as fast as firmware / board allows
arm_boost=1

[cm4]
# Enable host mode on the 2711 built-in XHCI USB controller.
# This line should be removed if the legacy DWC2 controller is required
# (e.g. for USB device mode) or if USB support is not required.
otg_mode=1

[cm5]
dtoverlay=dwc2,dr_mode=host

[all]