Raw_Data.txt

; This example of configuration data sets up a 10.000 MHz output on channel 0
; using the onboard 25 MHz crystal. For more information, consult Si5351
; AN-619 application note.
; More information on this file's syntax is available when you click
; on the "About..." button.
;
; Proposed a, b and c parameters required on MSNA and MS0 registers
; 
; 25 MHz x 30
; -----------  = 10 MHz
;     75
; 
; MSNA
; ----
; a=30, b=0, c=1  ->   MSNA_P1 = (128 x 30) - 512 = 3328 = 0x0D00
;                      MSNA_P2 = 0
;                      MSNA_P3 = 1
; MS0
; ---
; a=75, b=0, c=1  ->   MS0_P1 = (128 x 75) - 512 = 9088 = 0x2380
;                      MS0_P2 = 0
;                      MS0_P3 = 1
;
;-----------------------------------------------------------------
; Actual register writes begin here
;
3,255;		Turn off all outputs
;	Power down all 8 output drivers
16,8;
17,8;
18,8;
19,8;
20,8;
21,8;
22,8;
23,8;
;	Write new configuration
15,0;		PLL Input Source
9,255;		OEB Pin Enable Control Mask
16,12;		CLK0 Control
26,0;		Multisynth NA Parameter MSNA_P3[15:8]
27,1;		Multisynth NA Parameter MSNA_P3[7:0]
28,0;		Multisynth NA Parameter MSNA_P1[17:16]
29,13;		Multisynth NA Parameter MSNA_P1[15:8]
30,0;		Multisynth NA Parameter MSNA_P1[7:0]
31,0;		Multisynth NA Parameters MSNA_P3[19:16] MSNA_P2[19:16]
32,0;		Multisynth NA Parameter MSNA_P2[15:18]
33,0;		Multisynth NA Parameter MSNA_P2[7:0]
42,0;		Multisynth0 Parameter MS0_P3[15:8]
43,1;		Multisynth0 Parameter MS0_P3[7:0]
44,0;		Multisynth0 Parameters R0, DIVBY4, MS0_P1[17:16]
45,35;		Multisynth0 Parameter MS0_P1[15:8]
46,128;		Multisynth0 Parameter MS0_P1[7:0]
47,0;		Multisynth0 Parameters MS0_P3[19:16] MS0_P2[19:16]
48,0;		Multisynth0 Parameter MS0_P2[15:8]
49,0;		Multisynth0 Parameter MS0_P2[7:0]
187,64;		Fanout Enable of the XO for passthrough fallback
177,32;		PLL Reset Suggested to write 0xAC  
3,254;		Power up output 0 driver
;
; End of Configuration data