LaserGRBL does not do 1 pass in Laser cut

[nissimzur]

I create a cut for plastic sheet. See attached.
The line is 0.3mm.
1 pixel on Photoshop that was convert to SVG.
From unknown cause the LaserGRBL do 2 or more cut passes.
Why? This is just double and triple the cut time and the cut is wider because of the temperature neer cut line.
Thank you
Dr. Nissim Zur
0.3 mm-cut.zip

[gmmanonymus111]

I'm 99% certain that LaserGRBL is not at fault here. It is your method generating the SVG file, and it generates 2 lines very close to each other. Generating with InkScape, my SVG file is cut only once.
Side note: There is no need for line width setting when engraving SVG files. Line width equals to your laser point (or rectangle).
tiger.zip

[nissimzur]

Maybe LaserGRBL is not at fault. But every SVG line has two sides. And LaserGRBL tries to cut both sides. No matter how the line is tiny.

[arkypita]

... But every SVG line has two sides...

This is not true. SVG lines are line and does not have sides.