laser engraves low porency only.

[Rwgiesbrecht]

hello everyone. I am new to the subject of laser and engraving, and I recently bought a laser vevor 5.5 and at first it worked very well for me. And when I did the Paso de Marco to see the engraving area, that route was also marked there. Afterwards, I tried to lower the Power to the frame and now it has no more recording power. Although I have maximum power and slow speed, it does not record me as deeply as at the beginning. Can you tell me what could be my problem?

[Tribo-2dot0]

O que você fez para diminuir a potência do enquadramento? Editou o valor no botão?

[Rwgiesbrecht]

yes that's how it is. The button was set to 3% power and I lowered it to 1%. but after giving 3 or more again, it still doesn't work for me.

[Tribo-2dot0]

A tradução está meio confusa aqui... poderia mostrar todas as suas configurações grbl e um print da caixa de edição do botão?

[Rwgiesbrecht]

good day. Here I send you the configurations.

[Tribo-2dot0]

O botão Frame está configurado para 3% de poder. Seu $30 está correto que é 1000. Se seu laser não está gravando verifique a parte de hardware, cabos e placas.

[Rwgiesbrecht]

okay. I'm going to check those parts thank you

[Rwgiesbrecht]

Well. I tried more with the machine part of the cables, changed the source to test and everything was the same. One thing I don't know if it's right. We did a test with a tester and the laser head only reaches about 6V. and on the Head it says that it is 12V. that is normal?

[Tribo-2dot0]

Os fios preto e vermelho que vão para o módulo tem que dar 12v... se possível teste com outra placa controladora.

[Rwgiesbrecht]

Well. I'm going to continue watching that. At the moment I don't have time to change the plate.