Running rough after pin soldering?! Help?

[papaxiclas]

Hello!
In a brand new board loaded and working with the hack I decided to unsolder the hall sensor wires and instead put some pins in order to connect the plug directly to the board.
Now it is running rough as you can see in this video
I have already checked continuity from the motor sensors to the processor and everything seems ok.
Any ideia on were to look next?
Thanks

[aash]

Hey,

1. double check that all wires reliably soldered.
2. check with another hub motor

if problem persists try reading signals from hall sensors with oscilloscope.

I was lucky, my problem was bad soldering on one of the power wires.