generic-smoothieboard.cfg

# This file contains common pin mappings for Smoothieboard. To use this
# config, the firmware should be compiled for the LPC176x.

# THIS FILE HAS NOT BEEN TESTED - PROCEED WITH CAUTION!

# See the example.cfg file for a description of available parameters.

[stepper_x]
step_pin: P2.0
dir_pin: P0.5
enable_pin: !P0.4
step_distance: .0125
endstop_pin: ^P1.24
#endstop_pin: ^P1.25
position_endstop: 0
position_max: 200
homing_speed: 50

[stepper_y]
step_pin: P2.1
dir_pin: !P0.11
enable_pin: !P0.10
step_distance: .0125
endstop_pin: ^P1.26
#endstop_pin: ^P1.27
position_endstop: 0
position_max: 200
homing_speed: 50

[stepper_z]
step_pin: P2.2
dir_pin: P0.20
enable_pin: !P0.19
step_distance: .0025
endstop_pin: ^P1.28
#endstop_pin: ^P1.29
position_endstop: 0.5
position_max: 200

[extruder]
step_pin: P2.3
dir_pin: P0.22
enable_pin: !P0.21
step_distance: .002
nozzle_diameter: 0.400
filament_diameter: 1.750
heater_pin: P2.7
sensor_type: EPCOS 100K B57560G104F
sensor_pin: P0.24
control: pid
pid_Kp: 22.2
pid_Ki: 1.08
pid_Kd: 114
min_temp: 0
max_temp: 250

#[extruder1]
#step_pin: P2.8
#dir_pin: P2.13
#enable_pin: !P4.29
#heater_pin: P2.6
#sensor_pin: P0.25
#...

[heater_bed]
heater_pin: P2.5
sensor_type: EPCOS 100K B57560G104F
sensor_pin: P0.23
control: watermark
min_temp: 0
max_temp: 130

[fan]
pin: P2.4

[mcu]
serial: /dev/serial/by-id/usb-Klipper_Klipper_firmware_12345-if00

[printer]
kinematics: cartesian
max_velocity: 300
max_accel: 3000
max_z_velocity: 5
max_z_accel: 100

[static_digital_output leds]
pins: P1.18, P1.19, P1.20, P1.21, P4.28