printer-anycubic-kossel-2016.cfg

# This file contains the configuration for the Anycubic Kossel delta
# printer from 2016. The printer uses the TriGorilla board which is an
# AVR ATmega2560 Arduino + RAMPS compatible board. To use this config,
# the firmware should be compiled for the AVR atmega2560.

# See the example.cfg file for a description of available parameters.

[stepper_a]
step_pin: ar54
dir_pin: !ar55
enable_pin: !ar38
step_distance: .0125
endstop_pin: ^ar2
homing_speed: 60
position_endstop: 273.0
arm_length: 229.4

[stepper_b]
step_pin: ar60
dir_pin: !ar61
enable_pin: !ar56
step_distance: .0125
endstop_pin: ^ar15

[stepper_c]
step_pin: ar46
dir_pin: !ar48
enable_pin: !ar62
step_distance: .0125
endstop_pin: ^ar19

[extruder]
step_pin: ar26
dir_pin: !ar28
enable_pin: !ar24
step_distance: 0.010989
nozzle_diameter: 0.400
filament_diameter: 1.750
heater_pin: ar10
sensor_type: EPCOS 100K B57560G104F
sensor_pin: analog13
control: pid
pid_Kp: 25.349
pid_Ki: 1.216
pid_Kd: 132.130
min_extrude_temp: 150
min_temp: 0
max_temp: 275

#[heater_bed]
#heater_pin: ar8
#sensor_type: EPCOS 100K B57560G104F
#sensor_pin: analog14
#control: watermark
#min_temp: 0
#max_temp: 130

[fan]
pin: ar9
kick_start_time: 0.200

[heater_fan extruder_cooler_fan]
pin: ar44

[mcu]
serial: /dev/serial/by-id/usb-Silicon_Labs_CP2102_USB_to_UART_Bridge_Controller_0001-if00-port0
pin_map: arduino

[printer]
kinematics: delta
max_velocity: 500
max_accel: 3000
max_z_velocity: 150
motor_off_time: 360
delta_radius: 99.8

#[delta_calibrate]
#radius: 50
#manual_probe:
#   If true, then DELTA_CALIBRATE will perform manual probing. If
#   false, then a PROBE command will be run at each probe
#   point. Manual probing is accomplished by manually jogging the Z
#   position of the print head at each probe point and then issuing a
#   NEXT extended g-code command to record the position at that
#   point. The default is false if a [probe] config section is present
#   and true otherwise.

# "RepRapDiscount 2004 Smart Controller" type displays
[display]
lcd_type: hd44780
rs_pin: ar16
e_pin: ar17
d4_pin: ar23
d5_pin: ar25
d6_pin: ar27
d7_pin: ar29