Vectric post processor? #49
Unanswered
stevempotter
asked this question in
Q&A
Replies: 1 comment
-
The grbl one you have seen is fine, the only improvement would be to add tool change support? If you are using ioSender you may configure VCarve to use direct output, I find it very convenient. |
Beta Was this translation helpful? Give feedback.
0 replies
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
I have finished the upgrade of my MPCNC to grblHAL on Phil Barrett's Teensy BOB, about to start testing! Is there a post processor for grblHAL that can be used in VcarvePro (Vectric)?
I have seen a grbl one, but I imagine it does not take advantage of speed improvements in grblHAL hardware.
Beta Was this translation helpful? Give feedback.
All reactions