Antena CC1101

[akeendev]

I acquired the CC1101 antenna module and, upon connecting it to the M5StickC Plus 2, configured the software to use the CC1101 module in the RF Module option. However, during the scan/copy process, signals are only detected when the device is very close to the antenna, regardless of the configured frequency.

I observed that by selecting the CC1101 module in the RF Module, accessing scan/copy to adjust the range to FXD [433.92 MHz], and then switching the RF Module to the M5 RF433 option, the device is able to capture signals at distances exceeding 20 meters, even with the CC1101 antenna connected.

This behavior suggests a potential inconsistency in the detection or configuration of the CC1101 module within the software, which impacts signal detection range under normal conditions.

Tests were conducted on version 1.8 of Bruce using the M5Stick Plus 2 and the LILYGO T-Embed CC1101.