Voron 2.4-300mm build

Klipper configuration for my Voron 2.4 printer (300x300x300)

* banana for reference

Setup

I'm running klipper firmware on a RaspberryPi4 connected via usb to two SKR 1.4 board.

Klipper and Octoprint

The process is pretty straight-forward: run the klipper dependencies installer, compile the firmware and flash it on the board. Install an octoprint plugin. It's done :)

Please refer to the offical documentation for details.

Contributing

This project, even if personal, it's meant open so feel free to contribute! These are the contribution guidelines.

This has been forked from rpanfili/voron-ht